Milwaukee PH-START Starter Solution Kit for pH Meters and Testers

Description

pH-START is set of storage, cleaning and calibration solutions designed to help you get the most out of your pH electrode. 

Included in the kit is lab grade pH 4.01 buffer solution (MA9004), pH 7.01 buffer solution (MA9007), pH/ORP electrode storage solution (MA9015) and pH/ORP electrode cleaning solution (MA9016). All bottles are 230 mL.

Milwaukee buffer solutions are certified to an accuracy of ±0.01 pH. By removing the
inaccuracies involved with mixing buffers, these buffer solutions help you achieve reliable
and repeatable pH measurements.

Milwaukee storage and cleaning solutions are designed to extend the life of your pH or ORP electrode. Keeping your sensor clean during calibration and measurement ensures accurate and repeatable readings.

In general, and depending on the frequency of use and the type of application, soak your pH or ORP electrode once per week in MA9016 Cleaning Solution for about 15 minutes. After soaking, remove the electrode, rinse with Distilled Water and put the MA9015 Storage Solution in the probe cap before storage. This will keep your pH or ORP sensor hydrated for the next use as the sensor needs to be hydrated for the ion exchange process to occur. 

If the probe sensor should become dry, storage solution can be used for reconditioning.

Design Features

• pH buffers certified to ±0.01 pH accuracy
• Storage and cleaning solutions are lab grade produced with premium chemicals
• Fundamental for the correct use of electrodes and for obtaining the most accurate and reproducible readings
• Sealed against light with air tight, tamper proof cap
• Marked with lot numbers and expiry dates
• 230 mL bottles

Included

• MA9004 pH 4.01 Calibration Buffer Solution (230 mL)
• MA9007 pH 7.01 Calibration Buffer Solution (230 mL)
• MA9015 Electrode cleaning solution (230 mL)
• MA9016 Electrode storage solution (230 mL)